M9106-GGA-2 | ROTARY ACTUATOR; 53 IN-LB/6NM NON-SRTN PROP 0-10VDC/0-20MA 0-10VDC FB W/COVER | Johnson Controls

ROTARY ACTUATOR; 53 IN-LB/6NM NON-SRTN PROP 0-10VDC/0-20MA 0-10VDC FB W/COVER

Description

The M9106-xGx-2 Series direct-mount electric actuators operate on AC 24 V power and are available for use with on/off, floating, or proportional controllers. These non-spring-return actuators are easily installed on a VAV box, a damper with a round shaft up to 1/2 in. (13 mm) in diameter, or a square shaft up to 3/8 in. (10 mm). The M9106 with an M9000-520 linkage can also be used to position VG1000 Series 1/2 in. (DN15) to 1-1/2 in. (DN40) ball valves.

The M9106 Series models have 53 lb·in (6 N·m) running torque. These actuators have a nominal 60-second travel time for 90° of rotation at 60 Hz (72 seconds at 50 Hz) with a load-independent rotation time.

The M9106-xGC-2 models are available with integral auxiliary switches to perform switching functions at any angle within the selected rotation range. The -GGx models feature DC 0(2) to 10 V position feedback, and the -AGF models provide 10,000 ohm position feedback.

Features

• simple direct coupling reduces installation and commissioning time and improves reliability by eliminating damper linkages; single screw coupling provides three-point shaft gripping
• designed for zone damper and ball valve actuator applications
• small, compact design allows installation in tight-fitting locations
• on/off, floating, and proportional control inputs
• 60-second running time at 60 Hz
• long life brushless synchronous drive motor technology provides constant running time independent of load
• robust 53 lb·in (6 N·m) torque rating
• whisper quiet 35 dBA noise rating
• magnetic clutch provides over torque protection over the entire range of rotation
• -4 to 125°F (-20 to 52 °C) ambient temperature rating
• 100,000 full stroke cycle, 2,500,000 reposition rating
• manual gear release simplifies setup and field adjustments
• 1/2 in. NPT threaded conduit opening meets electrical code requirements and allows the use of flexible armored cable
• position feedback (-GGX models) provides simple, closed-loop control with accurate position sensing
• adjustable rotation stops allow application versatility with 30 to 90° clockwise or counterclockwise rotation

Applications

The M9106 actuators are used to position balancing, control, round, and zone dampers in typical HVAC applications. The M9106 can also be used with an M9000-520 linkage to control 1/2 in. (DN15) to 1-1/2 in. (DN40) VG1000 Series ball valves. The M9106 Series actuator mounts directly on the duct surface, round damper, or small rectangular damper with an anti-rotation bracket and two sheet metal screws (included). Additional linkages or couplers are not required. Refer to the damper or VAV box manufacturer’s information to select the proper timing for the actuator. Refer to the appropriate application note for specific wiring diagrams and information.