Posted by Adem Erturk on

Converting Analog, Floating Point, or Pulse to Resistance

Its triac compatible. Has a removable resistance card. Converts Floating Point (digital up/down), Pulse, or Analog signals to Resistance.

The DRN3.1 incorporates features many requested. Converts Anal og, Floating Point, and Pul se Wi dth Modulated signals to a Modulating Resistance Signal, and mounts in a plastic snap track (provided). The DRN3.1 features:

  1. No Wrap Around! Increasing the input beyond upper range will not cause the output to start over at lowest value
  2. If your digital output is triac that's OK with the DRN3.1.
  3. Output is electrically isolated from input. Minimizes connection problems.
  4. Power LED and two signal LED indicators. You can tell at a glance what the DRN3.1 is doing.
  5. Lose power? Its Fail-safe! Control reverts to original controller or a fixed resistance
  6. Floating Point Input has 3 field selectable ramping times.
  7. Offset is field selectable

Converting Analog, Floating Point, or Pulse to Resistance

Part Number
Type
Electrical Connections
Features
DRN3.1
Analog, Pulse or Floating Point to Resistance Transducer (Input signal types are jumper selectable)
45 degree Screw terminal for 22 to 14 gage wire
Current or Voltage Input (6 ranges - jumper selectable), pulse input (3 ranges - jumper selectable), Floating point input ( 3 rates of change - jumper selectable), 12 standard plug-in resistance output cards (optional fine tuning adjustment) in 135, 500, and 1000 ohm, etc., plus custom (to your specifications) output cards available

 

See All DRN3.1 Products


Older Post Newer Post


0 comments


Leave a comment

Please note, comments must be approved before they are published