Need to stage 2 analog devices where the 2nd is needed only if the 1st isn’t enough? We do it from one analog signal?
Here’s how. Using one (1) AIM1, one (1) ARM and a 24 VAC power supply, set up in the following configuration:
AIM1 - Set J1 to 5 VDC, J2 to 10 VDC and J3 to E)
ARM - Calibration should be 5-10 VDC in and 0-10 VDC out Factory calibration is available
Connect your input signal to both AIM1 and ARM. Connect the first controlled device to the AIM1 and second to the ARM. Connect the power supply.
Vin | 0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 |
Vout1 | 0 | 2 | 4 | 6 | 8 | 10 | 10 | 10 | 10 | 10 | 10 |
Vout2 | 0 | 0 | 0 | 0 | 0 | 0 | 2 | 4 | 6 | 8 | 10 |